VW Vortex - Volkswagen Forum banner

Block 093 cam phase

2K views 0 replies 1 participant last post by  vtraudt 
#1 ·
I showed -8 and zero in block 093 (field 3 and 4).
And misfire counter (015 and 016) stayed 'enabled', with occasional 'count' (not enough to trigger misfire CEL).
Decided to do timing belt service.
Cam lock bar was about 1/2 off.
Cam sprockets (lock bar), crank position TDC now right on.

BUT, block 093 still shows -5 and +2 (total of 7) phase.
Blocks 90-92 show zero (or + or - 1).

Exhaust cam position is locked by cam bar. Intake cam position is measured (one impulse per rev) by cam sensor.

I did NOT check the intake cam position marks (cam chain links).

What are values in blocks 090-092 and what does "Phase" in block 093 mean?

How would one chain link off (cam chain) show up in measuring blocks?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top